Troubleshooting Tips; Brief Operating Instructions - ARC Computer COM-ON-AIR PLUG Bedienungsanleitung

6

Troubleshooting Tips

Symptom Cause
Grip of the line impossible, The connective is not correctly
no tone of invitation to dial linked with the terminal
the number
The power adaptator is not
correctly connected
The line is taken by another
terminal
Radio link with the base The COM-ON-AIR
impossible (tone of absence is not synchronised
of synchronisation)
The base is not activated
The telephone linked with the The volume of the bell is too
interface does not ring weak
Error in the programming of
the sending of appeals on the
base
Audible humming in the lin- Disturbances
ked telephone
Remedy
Verify the connection of the
connective in the terminal,
disconnect then plug
COM-ON-AIR ® P L U G
first disconnect, then plug
P L U G
COM-ON-AIR ®
on power supply
wait until the line is free
® P L U G synchronise the COM-ON-
AIR ® P L U G
activate the base
increase the volume of the
telephone
activate the base
increase distance separating
® P L U G
COM-ON-AIR
from the telephone
(minimum 2m).
12
7

Brief operating instructions

A telephone is to be plugged on the COM-ON-AIR
Declaration: • pick up the line
• plug COM-ON-AIR
• dial #
• dial 1
• dial the COM-ON-AIR
• dial the COM-ON-AIR
• dial #
Volume: • pick up the line
• plug COM-ON-AIR
• dial #
• dial 2
• dial the volume level (between 1(low) and 5(high))
• dial #
change basestation: • pick up the line
• plug COM-ON-AIR
• dial #
• dial 3
• dial the new base number(between 1 et 4)
• dial #
default settings: • pick up the line
• plug COM-ON-AIR
• dial #
• dial 0
• dial #
P L U G to enter program menu.
®
P L U G on power supply
®
® B A S E number (between 1 et 4)
® B A S E pin code (default settings 1111)
® P L U G on power supply
® P L U G on power supply
® P L U G on power supply
13