Salter BPW-9154 MiBody Bedienungsanleitung Seite 6

PAIRING DEVICES
GB
1. Turn Bluetooth "On" in the "Settings" menu of your iPhone/iPad.
2. Open the MiBody App.
3. Press the button to enter "Settings".
4. Press the button.
5. Press the button.
6. When the blood pressure monitor is off press and hold the
7. On your iPhone/iPad, touch the blood pressure monitor icon to connect with the blood pressure monitor. Select the user
number you wish to pair. Touch the Done button to finish.
8. If pairing is successful [] will be displayed.
9. If pairing is unsuccessful E1 will be displayed.
10. The blood pressure monitor will automatically switch off.
11. Repeat procedure for each user and each iPhone/iPad.
Note: Each user number can only be paired with one iOS device. Results will be sent to the paired device only.
POSITIONING THE CUFF
1. Remove all accessories (watch, bracelet, etc) from your left wrist. If your physician has diagnosed you with poor
circulation in your left wrist, use your right wrist.
2. Roll or push up your sleeve to expose the skin.
3. Apply the cuff to your left wrist with your palm facing up.
4. Position the top edge of the cuff about 1-1.5cm from the wrist.
5. Fasten the wrist cuff around your wrist, leaving no extra room between the cuff and your skin. If the cuff is too loose, the
measurement will not be accurate.
6. During measurement the monitor should be level with your heart.
BLOOD PRESSURE MEASUREMENT
1. After correctly positioning the cuff ensuring the monitor is level with your heart press the
on and the user number is displayed.
SET
2. Press or button to change the user number.
SET
MEM
MEM
3. Press button to confirm and start the measurement.
START
STOP
4. Measurement is automatic and takes approximately 30 seconds. The monitor will inflate and squeeze your wrist. After
measurement the monitor will deflate and the results will be displayed on the screen.
5. If the user number is paired with an iPhone/iPad
device.
6. If the device is out of range or the App is closed
transferred next time the monitor is used.
Note: To receive data the MiBody App must be open or running in the background. The MiBody App will not receive data if it
is closed completely or Bluetooth is turned off.
Caution: Data is not saved or transferred for GuESt users.
button until is displayed on the screen.
START 0
0
STOP
will be displayed and the data will be sent wirelessly to your mobile
will be displayed and the data will be saved on the monitor and
6
button. The monitor turns
START
STOP