For The First Time; Mincing Meat - Klarstein 10006874 Bedienungsanleitung

 After use, there would be a little food left in the grinder head. This is normal. There might be a bit of
black metal powder adhering to the food ground in the end. Please pick them out and throw away,
do not eat them.
 To avoid jamming, do not force to operate the unit with excessive pressure.
 When the circuit breaker activates, do not switch on.
 Never try to replace the parts and repair the unit by yourself.
 This appliance is not intended for use by persons(including children) with reduce physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.

If the supply cord is damaged,it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
 Children should be supervised to ensure that they do not play with the appliance.
 Check that voltage indicated on the rating label corresponds the mains voltage in your home.
 Wash all parts (except body) in warm soapy water.
 Before plugging in, ensure the "ON/0/ R" switch is turned to "O" position.
ASSEMBLING
 Holding the head, insert it in the inlet (fig.1). Rotate
the head in the same direction as fig.2 until a small
sound can be heard. The head has been placed in the
inlet. Try to rock the head slightly to ensure it is placed
well.
 Place the feed screw into the head, long end first, by
turning the feed screw slightly until it is set into the
motor housing (fig.3).
 Place the cutting blade onto the feed screw shaft with
the blade facing the front as illustrated (fig.4). If it is
not fitted properly, meat will not be ground.
 Place the desired cutting plate next to the cutting
blade, fitting protrusions in the slots (fig.5).
 Support or press the centre of the cutting plate with
one finger then screw the fixing ring until tight with
another hand (fig.6). Do not over tighten.
 Place the hopper plate on the head and fix into
position.
 Locate the unit on a firm place.
 The air passage at the bottom and the side of the
motor housing should be kept free and not blocked.

MINCING MEAT

 Cut all foods into pieces (Sinewless, boneless and fatless meat is recommended, approximate size
:20 mm x 20 mm x 60 mm) so that they fit easily into the hopper opening.
 Plug in and turn the "ON / R " switch to " ON" position, then turn the "ON/0/ R" switch to "ON"
position.
 Feed foods into the hopper plate. Use only the food pusher (fig.7).
 After use switch the unit off and unplug it from the power supply.

FOR THE FIRST TIME

INSTRUCTION FOR USE