Possible Malfunctions - Bartscher Compact Ice Bedienungsanleitung

7. Possible Malfunctions

PROBLEM
The indicator
lights up
The indicator
lights up.
The indicators
lights up.
Ice cubes stick to each
other.
The ice cube making
process is normal but
does not produce any
ice cubes.
The ice cube making
process is automatically
stopped. The indicator is
flashing on the control
panel.
If a malfunction occurs, disconnect the unit from its power source. Before
contacting a service agent, try to solve the problem following the steps given
above. If you cannot remove the malfunction, contact a service or sales agent to
inspect and repair the unit.
POSSIBLE CAUSES
No water.
Too much ice in the ice
cube basket.
The water temperature in
the container is too low.
Ice scoop is immobilised.
and
The ice cube making
process is taking too
long.
The water temperature in
the container is too low.
The room temperature or
the water temperature in
the container is too high.
Cooling agent has run
out.
The cooling tubes are
blocked.
The power supply was
cut off by mistake during
the ice cube making
process.
SOLUTION
Switch off device, fill up with
water and switch on again.
Remove ice from the ice cube
basket.
Check whether ice is blocking
the ice scoop. If not this is not
the case, contact retailer
Switch off device and switch
on again when ice cubes are
melting. Select S – small to
produce smaller ice cubes.
Change the water in the
container. The optimal tempe-
rature for water is 7° -32° C.
Make sure room temperature
is below 32° C and put colder
water into the container.
Contact retailer
Contact retailer
Switch off the device and pull
the plug not the cable. Wait for
a few minutes, and then
carefully remove the ice
cubes. Switch on again.
- 27 -