oneConcept 10029373 Bedienungsanleitung Seite 32

IMPORTANT: Do not install the batteries backwards. You can permanently damage the ther-
mo-hygrometer. Do not use rechargeable batteries. Note: We recommend installing Lithium
AA batteries.
Reinsert the battery door into anemometer transmitter and push to tighten it.
The wind sensor LED indicator will light for 3 seconds, and then flash once per 16 seconds
thereafter. Each time it flashes, the sensor is transmitting data.
Note: If the wind sensor does not power up after inserting the batteries, press the reset
button shown in figure on bottom of the last page.
Insert batteries into the rain gauge transmitter
Rotate and detach the upside bucket, arrow di-
rection.
The Rain gauge sensor LED indicator will light for
3 seconds, and then flash once per 60 seconds
thereafter. Each time it flashes, the sensor is
transmitting data.
32
Locate the battery boor on the rain
gauge transmitter, pull out the bat-
tery compartment.