Himsa NOAHlink Bedienungsanleitung Seite 33

NOAHlink Users Manual
The following table describes how to use the Advanced Settings tab:
SETTING
NOAHlink
power off
time
HI power
status
Power on
when
leaving
cradle
Driver
COM Port
Settings
30
OPTION
Set the time
length before an
idle NOAHlink
powers off
Turn hearing
instruments on
automatically
with NOAHlink
Set NOAHlink to
power on
automatically
when removed
from its cradle
Change the
driver
Scan ports to
locate
NOAHlink
PROCEDURE
 Select the length of idle time
before NOAHlink powers off
OR:
 Select Off for NOAHlink to
remain on indefinitely
 Select On to turn on hearing
instruments automatically when
NOAHlink powers on
 Select Off for hearing
instruments to be turned on
through the fitting module
 Select On for a previously
powered on NOAHlink to
power on automatically when
removed from its cradle
 Click Change. A File Menu
appears.
 Select the driver after browsing
for its location
 Click OK
NOTE: Only select new values if
your system CANNOT
locate NOAHlink
 Use the pull-down menus at
COM Port low and COM Port
high to select new values.