Swim & Fun 1057 Bedienungsanleitung Seite 37

2. The heater can be connected by the system's pump intake or outlet (Fig. 2)
3. PVC pipe: (Fig. 3) cut a suitable piece of PVC pipe/hose from the pump's intake/outlet and
mount it on the heater's fitting valve.
NOTE: The connection pipe/hose must have the same diameter as the rest of the pipe system in
the spa/hot tub.
4. The hose coupling/pipe connection (Fig. 4) Clean the surfaces to be glued and glue the pipe/
hose carefully into the heater's coupling sleeve. Please note the installation distance between
the pump and the heater.
MV-1055-1057-09-2018 www.swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS 2018
Page 37