Preparing The Appliance For Operation - SNAIGE CD290-1004 Betriebsanleitung

Do not climb on or sit on the appliance, do not lean on or hang on the appliance
•
doors.
The appliance should be transported only in the vertical position. The
manufacturer will not be responsible for any damage of the appliance that
results from non-compliance with the instructions for transportation.
The manufacturer guarantees reliable operation of the refrigerator when the
ambient temperature is +16 to +32 degrees celsius and the relative air
humidity not greater than 60 per cent.
The models CD350-1313, CD350-311: the manufacturer guarantees
reliable operation of the refrigerator when the ambient temperature is +16 to
+32 degrees celsius and the relative air humidity not greater than 70 per cent
• Place the appliance in a dry, well ventilated room.
WARNING! The appliance should not be operated in an unheated room or
porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight. The appliance must not touch any
pipes for heating, gas or water supply or any other electrical devices
• Do not cover the ventilation holes at the top of the appliances – it must be a good air circulation
around the appliance. There should be a gap of at least 10 cm between the top of the appliance
body and any furniture that may be above it. If this requirement is not followed, the appliance
consumes more electrical energy and its compressor may overheat.
• If the appliance is placed in a corner, a gap of at least 1 cm must be left between the appliance
body and the wall (see fig. 2, page 2).
• The appliance must stand on a level surface and must not touch the wall. If necessary, regulate
the height of the appliance by adjusting the levelling feet: by turning them clockwise – the front of
the appliance rises, by turning them counter clockwise – it comes down. If the appliance is tilted
slightly backward – the doors will close by themselves.

PREPARING THE APPLIANCE FOR OPERATION

It is recommended to prepare the appliance for operation with a helper.
Remove package. Lift the appliance away from foamed polystyrene base.Therefore take
•
out adhesive tapes from sides and simply lift the appliance up and take out the
board. Strip adhesive tapes off and open the door. Remove the spacer above the door.
When positioning the appliance in chosen location, it will move more easily into position
•
if you lift the front a little and incline it backward allowing it to roll on its casters. When
placing, moving, lifting the appliance, do not hold the door handles, do not
pull the condenser at the rear part of the refrigerator and do not touch the
compressor unit.
Take two supports from the bag (see fig. 4, page 2) and insert them into the guides at
•
the top back part of the appliance.
Wait at least 4 hours before connecting the appliance to the power
supply. If this is not done, the appliance compressor may fail.
The appliance should not be connected to the mains until all packing and transport
materials aren't removed. Suitably dispose the packaging material.
POSITIONING
5
.