Control Pads - G21 INTENSE-SERIES Bedienungsanleitung

Control pads on the dehumidifier
Note: the control panel of the unit you purchased may be slightly different according to the models.
Some models can be controlled by remote controller. Some models have no remote control func-
tion. Please refer to the remote controller instructions for the remote operation.
Ion operation
High fan
on indicator
indicator light
light
7 6

Control pads

When you push the button to change operation modes, the unit will make a beep sound to indicate
that it is changing modes.
1. Power pad
Press to turn the dehumidifier on and off.
2. Mode pad
Press to select the desired operation mode from Dehumidifying, Dryer, Continuous dehumidifying
and Smart dehumidifying.
Note: Dryer and Smart dehumidifying modes are optional.
3.4. +/- Down/Up pads
• Humidity set control pads - The humidity level can be set within a range of 35% RH (relative
humidity) to 85% RH (relative humidity) in 5% increments.
o For drier air - press the – pad and set to a lower percent value (%).
o For damper air - press the + pad and set a higher percent value (%).
• Timer set control pads - Use the up/down pads to set the Auto start and Auto stop time from
0.0 to 24.
5. Timer pad
Press to initiate the Auto start and Auto stop feature, in conjunction with the + and – key pads.
6. Turbo pad
Control the fan speed. Press to select either High or Normal fan speed. Set the fan control to High
for maximum moisture removal. When the humidity has been reduced and quiet operation is pre-
ferred, set the fan control to Normal.
7. Ion Pad
Press to activate the ionizer. Anions are automatically generated by ionization. The anions deactive
the airborne chemical vapors and dust particles. Press it again to stop the function.
Bucket full
indicator
Timer on/off
light
indicator light
8
5 4
Continuous
Dryer
operation
operation
on indicator
on indicator
light
light
3
Smart de-
humidifying
operation
on indicator
light
Unit operati-
on on indica-
tor light
2 1