Accessories; Safety Precautions; General Safety Precautions; Behaviour At The Place Of Work - EFA Z 08 Betriebsanleitung

1.4 Accessories

The order numbers for both the parts contained in
the scope of supply and for accessories can be
found in Annex A.3 "Cutter sizes" (p. 33).

2. Safety precautions

2.1 General safety precautions

Be sure to observe the following safety pre-
cautions when working with the cutter.
Changing the blades as well as installation,
maintenance and repair work may only be car-
ried out when the machine is disconnected from
the power pack!
Select personal protection equipment according
to the regulations applicable on the premises
and to the accident prevention regulations in
force.
It is assumed that the operating personnel is
sufficiently familiar with the use of cutters!
The operators must be instructed by our special-
ist personnel!
Installation, maintenance and repair work may
only be carried out by authorised and qualified
personnel
Cutters from S&W comply with the relevant
safety regulations
The cutters are equipped with a two-hand
safety circuit. The two switches have to be
pressed simultaneously (within 0.3 seconds).

2.2 Behaviour at the place of work

1. Keep your place of work tidy. Untidiness can
lead to accidents.
2. Give consideration to environmental influences.
Ensure good lighting (min. 500 lux).
3. Keep other people away from your place of
work. Work in a concentrated and sensible man-
ner. Do not use the cutter when you are uncon-
centrated and/or tired.
4. Store the cutter in a safe place. Store the saw in
a dry place when not in use.
5. Work clothing: Do not wear loose clothing or
jewellery as these could become tangled up in
moving parts. Wear solid shoes when working.
Wear a hair net as a general rule!
6. Avoid abnormal body postures. Ensure a safe
working position and keep your balance at all
Schmid & Wezel
D 75433 Maulbronn
times.
7. Service your tools with care. Use only sharp and
undamaged blades so that you can work better
and safer.
8. Use only original EFA blades. Follow the instruc-
tions given under "Changing the blades". See
also Chapter 4.1.1 "Changing the blades" (p.
26).
9. Do not leave wrenches on the machine. Check
that all wrenches have been removed before
starting the machine.
10.Use only original EFA accessories. Use of other
accessories will void the warranty. Use of other
tools or accessories may increase the risk of
injury.
11.Modifications and changes to the machine are
not permitted and will relieve S&W of any war-
ranty and liability.
3. Commissioning and opera-
tional safety
Place of work
The working area for the operator should be at
least 15 square feet. No other place of work should
extend into this area, as the movements with the
cutter could result in the risk of injury. .
The illumination at the place of work must be at
least 500 lux.
Seite/ Page
23/ 39
Ausführung/ Version
05.2007