Operation, Scope Of Supply, Accessories; Symbols In This Manual; Intended Use; Residual Risks - EFA Z 08 Betriebsanleitung

1. Operation, Scope of Supply,
Accessories
Notes, read carefully!
This manual is intended for the machine operator.
Keep it in a safe place!
The cutters may only be operated:
In a technically safe condition, for its intended
use and in accordance with the applicable safety
and accident prevention regulations
With all the safety devices attached
In accordance with the safety precautions
When the operating personnel has read and
understood this manual, in particular Chapter 2
"Safety precautions" (p. 23) and Chapter 3
"Commissioning and operational safety" (p. 23)
Only in this way can incorrect operation be avoided
and hazard situations correctly assessed.
Never reach into the cutting area
of the cutter to avoid the risk of
cutting off limbs!
Wear eye protection or safety
goggles when working with the
saw!

1.1 Symbols in this Manual

Hazard symbol:
The greatest care and attention must
be taken here. Lack of attention can
result in an immediate risk of injury for
the operating personnel or third par-
ties. Furthermore, the machine may
be damaged.
Information symbol:
Texts marked with this symbol con-
tain important information and useful
tips.

1.2 Intended Use

The cutters are designed for separating meat con-
taining bone in non-frozen or partially frozen state
(from approx. -5° C).
The cutter is suitable for cutting and breaking oper-
ations in medium-sized and large plants.
Schmid & Wezel
D 75433 Maulbronn
EFA Z 08: For cutting off the trotters and hocks of
pigs at the joint.
EFA Z 12: For cutting off horns and legs of cows.
EFA Z 14: For separating cow legs.
The machines are not equipped for any other form
of use. Should the operator wish to use the saw in
some other way, please consult Schmid & Wezel
GmbH & Co. (S&W) beforehand.
Use in any other way may result in a risk of acci-
dents and increased wear to the saw. The user
alone bears the liability for the consequences of any
other form of use.

1.2.1 Residual risks

During industrial use of the cutters on animal car-
casses there is a risk of injuring yourself or, in the
case of gross negligence, of killing someone.Since
during the intended use, the size of the opening be-
tween the cutter knives cannot be reduced, there is
a risk of the neck or upper arm or even the shoulder
joint coming between the cutter knives and the cut-
ter then being closed. Improper use of the cutter
could thus lead to instant death or to death by
bleeding. . Be sure therefore to always use the ma-
chine in the proper manner.
The cutter requires a hydraulic power pack to gen-
erate the cutting force, for 2-hand operation also a
pneumatic control unit.
The machine itself cannot build up any pressure.
The pressure is only built up in conjunction with the
upline pressure generator and the corresponding
hoses. The machine may only be put into operation
when all the requirements of the Pressure Vessel Di-
rective applicable to this product have been ob-
served.
The machine is designed for a pressure of 200 bar.
⋅
A value of
p V 240
pressure volume in the cutters and in the pressure
generator and hoses. The Pressure Vessel Directive
97/23/EC with the corresponding diagrams general-
ly applies to these elements.In view of the sturdy
design with respect to strength, torsional rigidity
and stability under static and dynamic operating
loads, however, we would refer you to Article 1.3.10
of the Pressure Vessel Directive 97/23/EC:
As the pressure constitutes no significant factor for
the design, the cutters are not subject to the provi-
sions of the above Directive.

1.3 Scope of Supply

Cutter
Operating manual
Seite/ Page
22/ 39
>
can be assumed for the
Ausführung/ Version
05.2007