Anc - Active Noise Cancellation; Anc - Ambient Mode; Voice Assistant; Phone Calls Via Bluetooth - Inline pure mobile Bedienungsanleitung

NOTE!
To delete the memory of playback de-
vices that have already been paired,
press and hold the multifunction button
for about 10 seconds with the headpho-
nes switched off. After the audio signals „Power on",
„Battery high" (depending on the state of charge, may
vary) and „Pairing", combined with the alternating flas-
hing of the LED in red and blue, the LED shows after
the 10 seconds by short, double flashing of the LED in
red that the reminder memory has been successfully
erased, followed by the renewed change into the pairing
mode, which is again acoustically signaled by „Pairing"
and the alternating flashing of the LED in red and blue.
c. ANC - Active Noise Cancellation
The InLine® PURE mobile ANC headphone features an
innovative technique for the active reduction of ambient
noise (ANC). You can switch this function on or off as
desired.
1. With the headphone switched on, press the ANC
button on the side of the control for about 2 se-
conds to activate the noise suppression. A se-
cond LED lights up white and signals the active
one Noise reduction mode.
2. To deactivate the noise suppression, press the
ANC button again for about 2 seconds. The se-
cond LED goes off.
NOTE!
If the InLine® PURE mobile ANC head-
phone is switched off after ANC was
active, the ANC must be reactivated
separately after switching it on again.
d. ANC - Ambient Mode
In this mode you can better perceive and amplify the
voice frequencies in your environment. So you can hear
announcements and even talk in a noisy environment wi-
thout having to remove the headphones.
1. Make sure that ANC is already active (see 8c).
Then briefly press the ANC button to activate the
mode. The white LED flashes to confirm.
info@inline-info.com
2. To deactivate the mode, briefly press the ANC
button again. The white LED goes off briefly and
then lights up again, so the normal ANC mode
is active again.
e. Voice assistant
To activate the voice assistant of your mobile phone,
press the multifunction key 3 times in quick succession.
f. Phone calls via Bluetooth
You can use the InLine® PURE mobile ANC headset to
make a call when the connected Bluetooth device is a
mobile phone. Thanks to the built-in microphones, you
do not need any accessories. For the Using the telephone
you can use the function keys of the control, which are
presented below in terms of their function.
Call back: To redial the last telephone connection, press
the multifunction button on the control element twice in
quick succession.
Answering a call: When there is an incoming call, press
the multifunction key once to answer the call. Press again
to end the call.
Rejecting a call: In the event of unwanted, incoming
calls, press the multifunction key for approx. 1 second.
Then release the button immediately, otherwise the head-
set will be turned off.
Change volume: You can control the volume during the
call using the „+" and „-" buttons.
Switch device: To continue the call with the mobile pho-
ne during a call, press and hold the multifunction button
for 2 seconds until the LED flashes blue.
Call pickup on a third-party call: If a third-party call is
received during a call, press the multifunction key to end
the current call and answer the incoming call from the
third party. To put the current call on hold and answer the
third party call, press and hold the multifunction key for
about 2 seconds.
11