Getting Started; General Functions; Status Lights; Parallel Audio Streaming And Audio Source Priorities - scala rider PACKTALK Bedienungsanleitung

4. GETTING STARTED

4.1 GENERAL FUNCTIONS

Power ON / OFF
Volume
Mute
Hear Your Buddy Name
Play Paired Buddy List
Enable / Disable VOX
(For Intercom / Voice Commands
only)

4.2 STATUS LIGHTS

None
1 BLUE flash every 3 seconds
1 GREEN flash every 3 seconds
1 RED flash every 3 seconds
2 BLUE flashes every 3 seconds
2 GREEN flashes every 3 seconds
2 RED flashes every 3 seconds
Solid RED

4.3 PARALLEL AUDIO STREAMING AND AUDIO SOURCE PRIORITIES

The scala rider PACKTALK can stream audio from two connected sources simultaneously,
so that you can listen to your music or the radio while holding an intercom conversation.
Parallel Audio Streaming is automatically disabled during mobile phone conversations.
By default, Parallel Audio Streaming is enabled. See section 3 to adjust the settings. If
disabled, the scala rider will automatically determine which audio source to play based
on the priority of the connected devices.
Higher Priority

1. Mobile Phone or GPS instructions
2. Intercom (DMC and Bluetooth modes)
3. A2DP (Stereo Bluetooth) audio
4. FM Radio (Built-in)
Lower Priority
*GPS instructions from Smartphone GPS Apps are prioritized like A2DP audio
A2DP audio priority can be configured to be higher than Intercom. See section 3 to adjust settings.
• Incoming mobile phone calls interrupt ongoing intercom calls
• Incoming intercom calls will interrupt FM radio
• Intercom modes all have the same priority - ongoing intercom calls will not be interrupted
by any other intercom call
π
Press for 2 seconds
ON: 3 BLUE flashes + ascending tone
OFF: 3 RED flashes + descending tone
Z
Roll the forward or backward to adjust and set volume
of current audio source
Z
Roll the backward and then forward very fast
Z
v
In Standby, press and
Z
In Standby, press for 2 seconds
Z
v
In Standby, tap and
• Enabled: Blue flash for 2 seconds
• Disabled: Red flash for 2 seconds
OFF
Standby in Bluetooth mode – No active audio
Standby in DMC mode – No active audio
Standby – Battery is low
Active audio in Bluetooth mode
Call in progress / music or other audio source is ON
Active audio in DMC mode
Call in progress / music or other audio source is ON
Active audio – Battery is low
Charging / USB connected
*
simultaneously for 2 seconds
simultaneously
|
7