Listening To Music Via A2Dp; Music Sharing - scala rider PACKTALK Bedienungsanleitung

6.3 LISTENING TO MUSIC VIA A2DP

Available only with A2DP/AVRCP compatible Bluetooth audio devices
ß
Play
ß
Pause/Stop
ß
Next Track
ß
Previous Track*
Music Scan
Stop Scan
*With some phones you may need to repeat this action
SWITCHING BETWEEN A2DP AUDIO SOURCES
If two A2DP audio sources are paired, the scala rider will use the default A2DP audio
source. To switch to the other audio source:
1. Stop the music playback from the current device.
2. Start music playback on the other device.
Your scala rider will automatically remember your last played device.

6.4 MUSIC SHARING

Music Sharing allows rider and passenger to listen to the same music within a
range of 33 ft / 10m.
Music Sharing works only in Bluetooth Intercom mode and with A2DP
(Bluetooth stereo) enabled audio sources. In order to share your music with your riding
partner, your scala rider [SENDER] needs to be paired to the other unit [RECEIVER] on
CHANNEL A and the RECEIVER must be in Standby mode.
[SENDER] Start/Stop
sharing your music:
[RECEIVER] Stop music
sharing:
Phone/Intercom calls and GPS audio navigation will override music playback.
Music Sharing does not transmit voice audio and cannot be used as an Intercom call.
In standby, tap π or use the Voice Command / Feature Menu
Press π for 2 seconds or use Voice Command
With music ON, tap π or use Voice Command
With music ON, double-tap π or use Voice Command
With music ON, tap and roll Z forward (scans up) or back (scans down).
The first few seconds of each audio track will be played.
To stop the scan on the current track, say any word loudly into the
π
microphone or tap
During A2DP music playback, press
v
Press for 2 seconds
v
for 2 seconds
|
17