Busy Signal; Receiving Intercom Calls - scala rider PACKTALK Bedienungsanleitung

FOUR-WAY INTERCOM
Pairing
1. Pair Rider 1 to Passenger 2 using Channel "A"
2. Pair Rider 3 to Passenger 4 using Channel "A"
3. Pair Passenger 2 to Passenger 4 using Channel "B"
In this configuration the two passengers (2 and 4) are each using two Bluetooth
connections:
Calling
1. Make sure the four units are not in an active phone or intercom call.
2. Passenger 2 should double-tap
both units.
3. Rider 1 should tap
4. Rider 3 should tap
5.2c CLICK-TO-LINK (CTL) INTERCOM MODE
Click-to-Link is a spontaneous way to instantly initiate 1-on-1 intercom calls with
other riders near you, without being paired. Think of it as a private channel that
you can set up on-the-go with other riders that you see along the way.
Click-to-Link can be disabled effectively blocking any attempt by a third party to send a CTL
request to you.
Start a CTL call request
(search lasts up to 10 sec.)
End a CTL call /
Cancel a CTL call request
Accept a CTL call
Reject a CTL call
Enable / Disable CTL
(Enabled by default)
If other riders are nearby, your next Click-to-Link call may randomly connect to any of them.

5.3 BUSY SIGNAL

When attempting to establish an Intercom call with another device that is already busy, a
"busy" signal will be heard. The scala rider is busy while on a phone call, intercom call with
Channels "A" and "B", "1+8" intercom call or CTL call.

5.4 RECEIVING INTERCOM CALLS

If a paired unit tries calling you via Intercom, the call will begin almost instantly.
to call Passenger 4. Wait until audio is heard on
v
to call Passenger 2.
v
to call Passenger 4.
v
v
In Standby, press
v
Tap
When hearing the CTL ringtone: Tap
answer by VOX
While hearing the CTL ringtone, remain silent until the ring tone
v
stops, or press for 2 seconds
See section 3
for 2 seconds
v
or say any word loudly to
|
15