Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Instruction Manual EFA SL24 WB
1. Connection and Initial Operation
The saw must be connected by a reputable electrician in accordance with the regulations of
the VDE and the local EVU. Before use, the operating data, power supply and works
equipment must be checked for conformity. The saw is equipped with a 4 m cable, plug and
socket as Standard.
2. Intended Use
2.1 Field of Application
For efficient use in the slaughtering and carving trade - for carving up cattle, calves and pigs.
Application in middle-sized and large-sized companies. In particular, advantageous for
quartering cattle halves - removal of thin flank from hindquarter and quartering of calves.
2.2 Operation
• Switch on saw
• Whilst saw is running place on carcass
• Whilst still running remove the saw from the carcass and then switch off.
2.3 Operational Safety
For safe handling (control), the saw should be suspended by a sprung-tensile force. Hold the
machine with both handles (33 + 75). When the machine is switched on be extremely careful.
Do not twist or jam saw blade. Disconnect machine from the mains before cleaning and
carrying out maintenance and repair work.
The air slit on both sides of the motor must be free from dirt - the motor must not be dipped in
water due to possible electrical dangers!
The saw is constructed in compliance with protection class II, international protection lP 24
(splash proof).
The motor casing (1) should not be drilled into (e.g. when affixing plates), äs the
effectiveness of the protective Isolation could be offset.
Hand held electrical machinery must be equipped with a protection cover (residual current
operated-device circuit breaker 30 mA) to increase safety (order No. 001 603 511). Machines
with extra-low voltage are exempt.
Printed in Federal Republic of Germany 12.2001
- 9 -
Änderungen vorbehalten
Warning!
Only valid for specialists in repairs
Laymen should not carry out any repairs
otherwise danger of accidents
Copyright by EFA
Werbung
