Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Maintenance
Disconnect machine from the mains. After use, the saw must be fully rinsed, in order to satisfy
the hygienic requirements.
During every maintenance check, the seal (49) on the handle and switch plate (42) must be
examined to see if they function properly.
Every 50 hour of Operation the machine must be maintained by lubricant (61) and with 3
squirts from the grease gun.
Lubricant: EFA special grease (0.8 kg). Order No. 001 365 613.
Changing of Saw Blades:
Disconnect plug from socket, unscrew both hexagon nuts (82) with ring open-end wrench,
remove hexagon screws (84) and saw blade (77) with Z-clamp (83). Assembly proceeds in
the reverse order.
4. Changing of Carbon Brush
4.1 Automatic Cut Off
If the carbon brushes (28) are worn out, the automatic cut off breaks the power supply and the
machine comes to a standstill. Through this the runnihg control of the carbon brushes (28) is
cancelled and the collector of the armature can not be damaged by the brush spring.
4.2 Note
WARNING! First pull the plug out of the socket. The carbon brushes (28) may only be
changed in pairs.
Printed in Federal Republic of Germany 12.2001
- 10 -
Änderungen vorbehalten
Warning!
When changing tools and before cleaning
or carrying out maintenance and repair work
disconnect from the mains
Copyright by EFA
Werbung
