LENCO EXP-5067 Benutzerhandbuch Seite 8

3. Press the FOLDER/10+ button once in play to skip to the track 10 tracks ahead, twice to skip to
the track 20 tracks ahead. You can reach the last track of the disc using this button.
SKIP TO THE PREVIOUS/NEXT FOLDER (MP3/USB)
1. During playback, press and hold the FOLDER/10+ button until the folder number indicate on the
screen.
2. Press the SKIP/SEARCH DOWN button or SKIP/SEARCH UP button to select the folder you want.
3. Wait several seconds or press the FOLDER/10+ button to confirm, the playback starts from the
selected folder.
REPEAT PLAYBACK (CD/MP3/USB)
During playback, press the MEM/MODE/PROG button to repeat play a single track; press the
button twice to repeat play all tracks; press the button three times to enter the random play mode;
press the button four times to exit.
PROGRAMMED PLAY (CD/MP3 DISC/USB)
1. In stop mode, press the MEM/MODE/PROG button once, the program's icon shows with a
program sequence indication "P01" first, then a track number flickers on the LCD with the
program's icon.
2. Select the first track to be programmed using the SKIP/SEARCH UP button or the SKIP/SEARCH
DOWN button, and then press the MEM/MODE/PROG button again to store and advance to the
next programming step.
3. Repeat the above steps to program more tracks. A maximum of 20 tracks for CD and 99 tracks
for MP3 disc/USB can be programmed in memory in a preferred order. If the memory is full, the
screen will show "FUL" for indicating.
4. Press the PLAY/PAUSE/CH+ button to begin programmed play in the preferred order after you
are done with programming. The player stops automatically after all programmed tracks are
played.
5. You may press the STOP/CH- button to terminate programmed playback. In program stop mode,
press the PLAY/PAUSE/CH+ button to begin the programmed playback with the programming
order identical with the previous one done; press the STOP/CH- button again to clear the
programming.
AUX IN
1. Connect the AUX IN jack on the unit to an audio source, for example, MP3 player with an audio
cable.
2. Power on the unit following the corresponding instructions.
3. Press the SOURCE button repeatedly to switch to AUX mode.
4. Use the native controls on the connected audio device to begin playing music through the
connected unit.
7