Electrolux IK2355BR Benutzerinformation Seite 12

12 www.electrolux.com
Problem
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The FastFreeze or Shop-
The temperature in the ap-
pliance is too low/too high.
All the temperature setting
LEDs flash at the same
time.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
Possible cause
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
ping Function function is
switched on.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
The FastFreeze function is
switched on.
There is no cold air circu-
lation in the appliance.
An error has occurred in
measuring the tempera-
ture.
Solution
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or
Shopping Function manually,
or wait until the function re-
sets automatically to set the
temperature. Refer to "Fast-
Freeze or Shopping Function
function".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "FastFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
Contact the nearest Author-
ized Service Centre. The
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible.