Installation; Installing/Replacing The Lamp; Danger To Life; Danger Of Fire - EuroLite DE-2 Super Policelight Bedienungsanleitung

If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.

INSTALLATION

Installing/Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one 230 V/100 W E-27 lamp.
During operation, the lamp reaches temperatures of up to 190° C.
Procedure:
Step 1: Unscrew the screw on the housing exterior.
Step 2: Remove the colour-cap.
Step 3: If replacing the lamp, remove the old lamp from the lamp-socket.
Step 4: Screw the new 230 V/100 W E-27 lamp into the lamp-socket.
Step 5: Replace the colour-cap and tighten the screw.
Rigging
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
The device can be installed on the ground or on the wall or ceiling.

DANGER TO LIFE!

Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened colour-cap!

DANGER OF FIRE!

14/31 50603050_V_3_0.DOC