Felisatti HF12,5/1050 Bedienungsanleitung Seite 4

those recommended in the instruction manual, may present
a risk of personal injury. Wheel intended for larger power tool
is not suitable for the higher speed of a smaller tool and may
burst.
Check before Use
1. Connection to Power Supply
2. Extension Cord
Use an extension cord if the
distance to the power source
requires its use. Extension cord
must be of appropriate thickness
and length for the supply of
electric current. Too thin or too long cord will cause voltage to
drop reducing the motor power. Use it as short as possible.
If the cord is damaged, have it repaired or replaced at A/S
center immediately.
3. Maintenance and Checking of Work Area
Work area must be checked using CAUTIONs in this manual
to ensure it provides appropriate environment.
4. Power Supply Check
Make sure that the power supply complies the requirements
described in the name plate on the Electric Hammer Drill.
5. Switch Status Check
if the power plug is connected when the power switch is
in ON position, sudden rotation of the moving parts of the
Electric Hammer Drill may cause accident.
Check if the switch lever returns to its original position when
it is pushed and pulled.
An explanation of any symbols or pictograms marked on
the tool relevant to safe use;
 - GB
Technical Data and List of Contents
1. Technical Data
parameter
Rated Voltage, V~
Rated frequency, Hz
Motor
Rated Input , W
No-load speed(bpm), /min
Impact Energy, J
Weight (Without cord, side
handle), kg
Protection Class
Tool holder system
Typical A-weighted sound power
level(LWA), dB(A)
Typical A-weighted emission
sound pressure level(LPA),
dB(A)
Triaxial vibration value:chiseling
(ah)(vibration vector sum), m/сІ
2. List of Contents
Plastic Box
Grease tube
Instruction Manual
1. Description of Functions
The overall look of the machine shown in Fig.1.
1 – Retainer SDS-max®
 - Selector
 - Jacket
 - Crank Case Cover(B)
5 - Grease Cover
6 - Crank Case Cover(A)
7 - Switch
8 - Handle
9 - End Cover
10 - Housing
11 - Gear Cover
1 - Crank Case
1 - Сap
2. Applications
Demolition of concrete Ramming, grooving, cutting, detach-
ing, angle forming, grooving on pebble road [Examples of ap-
plication] Cooling/heating constructions, piping/wiring works,
sanitary equipment installations, installation of machineries,
water supply/sewage works, interior works, port facilities
engineering, other engineering, equipment installation and
repair works.
Mounting/Dismounting of Tools and Operating Method
1. Mounting / Dismounting the Tools
To mount the tool, push the tool in while pushing the retainer
backward in the direction of the arrow. To dismount, pull out
the tool while pushing the retainer again backward in the di-
rection of the arrow.
2. Mounting the Jacket
The Jacket of both HF12,5/1050
by turning it 180°. Mount it the way user feels most comfort-
able.
HF12,5/1050
0
50
Protection-type Single-
phase Commutator
1050
500
1,5
5,
II
SDS Max
100
89
11,5
(Fig.2)
(Fig.3)
Hammers can be mounted