Herunterladen Diese Seite drucken

Vivaria Air 120 Betriebsanweisung Seite 12

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Persons who have not read and understood the operating instructions should not
use the air pump!
This device is not intended for use by persons or children with impaired physical, sensory
or intellectual impairments, or if lacking in experience and or know-how, unless they are
under supervision or have been trained in the use of the device by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the device.
Application
This air pump is designed for aerating ponds, filters and aquariums. The pump is not
suitable for use in water.
It may not be used in swimming pools!
For technical information on the air pump, see the nameplate or the table on page 2.
Safety instructions
-
Warning! This air pump may only be used if the electrical system meets relevant
statutory requirements. If in doubt, consult a qualified installer.
-
The pump should be connected to a system with a ground-fault interrupter (FI,
30mA) and earthed power outlet.
-
The mains voltage and current type must match the information on the nameplate.
-
Place the power outlet in a moisture-free area, at least 2m from the water's edge.
(see figure 1, page 2)
-
Locate the pump such that it cannot fall into water. It should also be protected from
moisture.
-
Warning! If placed on a smooth base, the vibrations may cause the pump to "walk"
during operation, so secure it in place by threading a rope through the hole at the
rear of the pump (A). (see figure 3, page 2)
-
Place the pump above water level (B). (see figure 3, page 2)
-
The air pump may only be installed indoors! Protect the pump from rain or other
sources of water.
-
Check the air pump, power cord and plug for damage before use.
-
Important: do not use if the air pump, power cord or plug is damaged. Bring it back
to your dealer.
-
Do not suspend or transport the air pump by the
-
power line (cable).
-
Do not move or suspend the air pump by the power cord.
-
Keep the plug and air pump dry. To prevent water from running from the cord or air
line to the plug or air pump, suspend the cord in a U-shape (see figures 2 and 3,
page 2).
-
When working on the air pump or in the water, always unplug the pump from the
electrical outlet to cut off the power supply.
-
Do not use the pump when there are people in the water.
-
The air pump should only be used above water level.
-
Place in a well-ventilated area to prevent overheating.
-
Protect the air pump from freezing.
English

Werbung

loading

Diese Anleitung auch für:

Air 240Air 480Air 960