Operation; Troubleshooting; Technical Specifications - Velleman CAMSET14 Bedienungsanleitung

RVV 2 x 32/0.2 W/1.0mm² cut area wire for electronic lock connection (reference distance < 25m)

4. Operation

• When the call button (fig.1 #7) is pressed, the monitor unit emits a chime sound and the visitor's image appears.
• Pick up the handset to communicate with the visitor. Put it down to end the communication - the monitor will be
switched off simultaneously.
• If there is no communication (handset is not picked up), the monitor will automatically switch off after 30 seconds.
• If you want to let the visitor in and an electronic door lock is installed, press the unlock button (fig.2 #10).
• Communication can also be established from inside: pick up the handset and press the 'monitor' button (fig.2 #8).
• Verify if anyone is at the door by pressing the monitor button without picking up the handset. To switch the monitor
off again, pick up the handset and put it back, or let the monitor auto switch off after 30 seconds.
• If more than 1 monitor unit is installed, the intercom button (fig.2 #9) can be used to call another monitor unit.

5. Troubleshooting

No image on the monitor
Image but no sound
Monitor remains on
Distorted image

6. Technical Specifications

Camera unit
Camera 1/4" CCD/CMOS
Resolution 352x288
Lens / angle F4.9mm / H = 40°; V = 31°; D = 50°
Min. illumination 0.1Lux
Light source 6 infrared LEDs
Dimensions 170x158x55mm
Monitor unit
Power Supply 100-240Vac
CRT 4" flat b/w
Resolution ≥380 TV lines
Call sound "ding dong" chime
CAMSET14
1. Check the power plug.
2. Check the contrast & brightness setting.
3. Check the wiring.
1. Check the handset spring wire.
2. Check the power plug (unplug and replug it).
3. Check the wiring.
1. Pick up the handset and put it back.
2. Unplug and replug the power plug.
Check for interfering cables (e.g. high voltage wire) or magnetic fields.
(order code spare camera unit: CAMSET14/CAM)
(order code additional monitor units: CAMSET14/MON)
3 VELLEMAN