Herunterladen Diese Seite drucken

Switching Hysteresis - PEHA 941 LUX Installations- Und Bedienungsanleitung

Daemmerungs- /sonnensensor

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Paul Hochköpper GmbH & Co. KG • Postfach 1727 • D-58467 Lüdenscheid • Tel.: (02351)185-0 • Fax: (02351)27666 • e-mail: peha@peha.de • Internet: www.peha.de
6. Technical data
941 LUX-REG evaluation unit
General data
Operating voltage
Current drain
Features
Load
Switch position display
Ambient temperature
Housing
Protection level
Sensor
Adjustment ranges

Switching hysteresis

Switch-on/switch-off delay
941 LUX-LF light sensor
Line length
Ambient temperature
Housing
Protection level
7. Warranty
These operating instructions are an integral part of both the appliance and
the terms of warranty. They must be furnished to the user. The technical de-
sign of the appliance is subject to change without prior notification. PEHA
products are manufactured using state of the art technologies in compli-
ance with prevailing national and international regulations, and are quality
tested. If the product should, however, reveal any defects, PEHA agrees to
correct these defects without affecting the rights of the end user to assert
claims against the vendor arising from the purchasing contract, as follows:
If the complaint is justified and properly filed, PEHA can choose to eit-
her correct the defect or supply a functioning product. Claims above and
beyond this, or compensation for follow-on damages are excluded. The
appliance is deemed to be justifiably defective when it is supplied to the
end user in an unusable or severely impaired state as a result of a design,
manufacturing or material error. The warranty does not apply to natural
wear and tear, improper use, incorrect connection, interference with the
appliance or external impacts. The warranty period runs for 24 months from
the purchase of the appliance by the end user from a vendor, and expires
at the latest 36 months after manufacture of the appliance. The settlement
of warranty claims is subject to German law.
941 LUX (Rev05_100121)
24 V DC
(from the 940 SPV PHC power supply)
max. 15 mA
Semi-conductor output, „open collector"
40 V / 50 mA
Undelayed, green control diode
- 10 to + 45°C
ABS
IP40, for distributor installation
Twilight
Sun
1–200 lux,
2000–200,000 lux,
logarithmic setting
logarithmic setting
Set at the factory
Continuously ad-
to 1.5 times
just- able between
the value of
0.2 and 0.8 times
the switch-on
the value of the
threshold
switch-on threshold
2s - 3min + 20%
2s - 6min + 20%
Max. 100 m for Ø 6 mm
- 25 to + 60°C
Polycarbonate
IP40
GB - 1

Werbung

loading

Diese Anleitung auch für:

941 lux-lf941 lux-reg