Technical Data; Before Using For The First Time; Assembly And Operation - EINHELL NEW GENERATION NRF 800L Bedienungsanleitung

Anleitung NRF 800L_SPK1
4.2. Additional safety instructions
Set up the machine on a level, non-slip floor.
Make sure that the machine does not wobble.
Check that the voltage on the rating plate is the
same as your supply voltage. Only then are you
to insert the power plug in the socket-outlet.
Wear safety goggles.
Wear ear-muffs.
Wear safety gloves.
Never use cracked diamond cutting wheels.
Replace immediately.
Caution! The cutting wheel runs on after the
machine is switched off!
Never apply side pressure to the diamond cutting
wheel in order to bring it to a halt.
Caution! The diamond cutting wheel must be
cooled with water at all times.
Always pull out the power plug before changing
the cutting wheel.
Use only suitable diamond cutting wheels.
Never leave the machine unattended in rooms
with children.
Always pull out the power plug before examining
the electric motor compartment system.

5. Technical data

Motor rating
Motor speed
A.c. motor
Insulation material class
Insulation
Cut length
Jolly length
Cut height 90°
Cut height 45°
Cutting table:
Dimensions
Diamond cutting wheel
Laser class
Laser wavelength
Laser output
Laser power supply
25.09.2006 8:48 Uhr Seite 11
Noise emission levels
The noise emitted by this saw is measured in
accordance with EN ISO 3744; EN ISO 11201
The noise at the workplace may exceed 85 db
(A). The user will require noise protection
measures if this is the case. (Wear ear-muffs!)
Sound pressure level L pA 94 dB(A)
Sound power level L WA

6. Before using for the first time

The machine must be set up so that it stands
firmly, i.e. it must be securely screwed to a work
bench, the base frame supplied in delivery, or
similar.
All covers and safety devices must be correctly
attached before the machine is used for the first
time.
The cutting wheel must rotate smoothly.
Check that the voltage on the rating plate is the
same as your supply voltage before you connect
the machine to the power supply.
800 W
3000 rpm

7. Assembly and operation

230 V ~ 50 Hz
Class B
7.1 Assembly (Fig. 1-6)
Fasten the feet (18) to the base frame (12) with
IP54
the 4 screws (19).
520 mm
Turn the sub-frame upright.
520 mm
Insert the two screws (37) for the trough fixture
max. 30 mm
through the square holes and place the trough
(3) in the base frame (12).
max. 25 mm
Fasten the cooling water pump (13) to the mount
(38). Place the tile cutter into the trough and
570 x 385 mm
screw on the trough fixture (39).
ø 200 x ø 25.4
Unscrew and remove the star handle screw (11)
2
and spacer (40) and keep them in a safe place.
Fill the trough with water until the cooling water
650 nm
pump is completely immersed.
< 1 mW
2 x 1.5 V (AAA)
7.2 RCD plug (Fig. 14)
Connect the RCD plug (37) to the power supply.
Press the reset button (38) and the control lamp
(39) will begin to shine. Press the test button (40)
to check the function of the RCD plug. If
everything is working properly the control lamp
(39) will go out and the contact to the power
supply will be interrupted. The RCD plug triggers
GB
With-load No-Load
operation operation
76 dB(A)
107 dB(A) 89 dB(A)
11