hanseatic HTF14155A1 series Gebrauchsanleitung Seite 58

Page GB-26 Troubleshooting table
Problem Possible cause
The appliance The temperature controller
doesn't cool suffi- (11) is set at too low a level.
ciently.
Door not tightly closed or
door seal is not completely
tight.
The appliance is near a heat
source.
Food has been stored warm. Only store cooled foods.
Too many goods frozen.
Thick ice layer in the freezer
area.
Ambient temperature too low
or too high.
Compressor seems defec-
tive.
Appliance is mak- Operating noises are func-
ing a noise. tional and are not a sign of
malfunction.
Disturbing noises.
Water has accu- Thaw water drain above the
mulated in the vegetable drawer is blocked.
fridge compart-
ment at the bot-
tom.
Solutions, tips, explanations
Select a higher setting (see „Setting the
temperature" on page GB-11).
See "Checking and cleaning the door
seals" on page GB-17.
Observe minimum distances (see page
GB-21). If necessary, place insulation plate
between the appliances or change loca-
tion.
Maintain maximum freezing capacity (see
„Product fiche concerning Regulation (EU)
Nr. 1060/2010" on page GB-29).
Defrost the freezer compartment (see „De-
frosting and cleaning the inner compart-
ment" on page GB-17).
Adjust the ambient temperature to the
climate category (see „Product fiche con-
cerning Regulation (EU) Nr. 1060/2010" on
page GB-29).
Set the temperature controller to "7". If the
compressor does not switch on within an
hour, please contact our service centre (see
page GB-27).
Humming: Refrigeration unit is running.
Flowing noise: Refrigerant is fl owing
through the pipes.
Clicking: Compressor is switching on or off.
Check that it is stable.
Remove any objects from the appliance.
Remove any foreign matter from the back
of the appliance.
Unblock the thaw water drain with the help
of the supplied cleaning swab.