Petsafe VT-800 Gebrauchsanweisung Seite 10

The Transmitter has two LEDs used to indicate the selected dog. The
Dog 1 Red LED is on the left when holding the unit with the LEDs
facing the operator and the Dog 2 Green LED is on the right.
The Transmitter is factory set in the Dog 1 mode. To verify, press and
release the Dog Select Button multiple times. (The Red LED will flash
once for each press and release.)
Transmitter Indicators
Condition
Normal Operation
Low Battery - press and release
the Top Button (light blue)
Dog 1 - The Top Button (light
blue) is pressed
Program Mode for adding Dog
2 - Dog Select button held for
5 seconds
Program Mode for removing
2nd dog - Dog Select button
held for 5 seconds
Charging
Condition
Normal Operation
Dog 2 - The Top Button
(light blue) is pressed
Charging Complete
10
Red LED
OFF
3 flashes every 5 seconds
ON length of Top Button (light
blue) press.
Blinks once at the start of the
5 seconds and once when it is
complete
Blinks once at the start of the
5 seconds and once when it is
complete
ON
Green LED
OFF
ON length of Top Button
(light blue) press.
ON
www.petsafe.net