Femi IB 500 Gebrauchs- Und Wartungsanleitung Seite 19

Care and Use of electrical components:
- Pay attention to the power supply cable: never use it to lift the edge banding machine. Do
not pull on the cable to disconnect the plug from the power socket. Keep the cable away
from sharp edges, oil and high temperatures.
- Should it be necessary to use an extension fl ex, make sure it is of an approved type.
- Regularly check the condition of the devices power cables. If damaged have them repaired
by an authorized assistance centre.
- Regularly check any extension fl exes being used and replace them if damaged.
- Whenever the edge banding machine is used outdoors, only use extension fl exes which
have been approved for outdoor use and are marked accordingly.
- Avoid contact with any earthed objects.
General safety precautions:
- Keep unauthorized persons and children away from the edge banding machine: never allow
them to come near or into contact with it.
- Always check what you are doing.
- DO NOT use the edge banding machine if you are tired.
- Always stay in a comfortable and well-balanced position.
- Never leave tools or measuring devices on the edge banding machine.
- Adopt safe working methods.
- Unplug the edge banding machine from the power supply when it is not in use, before
performing any maintenance operations and before replacing accessories or tools.
- Keep your face away from the working area to avoid inhaling any fumes which may be
generated by oily substances found on materials.
Safety checks:
- Remove the adjustment pins and spanners. It is a good rule to check that adjustment
spanners have been removed from the edge banding machine before switching it on.
- Avoid inadvertent start-up: make sure that the switch is in the stop position before connecting
the edge banding machine to the power supply.
- Check the various edge banding machine elements to make sure there are no signs of
damage.
- Before proceeding to use the edge banding machine, check all the safety devices and any
other item which may be damaged to ensure that the machine works properly and can
perform the task it is designed to do.
- Check that mobile parts are well aligned, move smoothly and are intact.
- Check the mounting and any other condition which may infl uence operation. Any damaged
part or guard must be repaired or replaced at an authorized after sales service centre.
- It is essential to avoid using the edge banding machine if the switch malfunctions in any
way.
- It is strictly forbidden to use the edge banding machine without the tool guards in place.
- Do not force the edge banding machine. The end results will be better and the edge banding
machine safer to use if it is used at the operating speed it was designed for.
EN
Cont....
15