Starting The Device - CLIMASTAR OPTIPLUS Bedienungsanleitung

5.SETTING UP

5.1- STARTING THE DEVICE

First, plug in the power cord to a mains power outlet, and click the switch on the right. Press
5.2- CONFIGURATION OF SETTING TEMPERATURE
Once the unit is ON, press
images below.
18 Grad
5.3 SELECT THE OPERATION MODE
There are 4 operating modes:
• Manual.
• Timer ON  OFF
• Timer OFF  ON
• Replay.
Manual Mode
The user determines the setpoint temperature.
To select temperature, press
Timer ON  OFF Mode
The device will work at the preset temperature as per user's configuration
To select the temperature, press
Press  to select the operating time. By pressing  repeatedly, operating hours or a combination of operating hours will be selected.
E.g.
To deactivate the timer function press  repeatedly until the time LEDs are deactivated
Timer OFF  ON Mode
The device will stop working as per user's configuration.
On starting the device again, press
Press during 2 seconds to switch to OFF mode.
Press  to select the switch-off time of the device. Press and hold  repeatedly to select the operating hours or the combination of
operating hours of the device. E.g.
To deactivate the timer function press  repeatedly until the time LEDs are deactivated.
Replay Mode
Press to select the desired temperature.
Press  to select the operating cycle. By pressing it repeatedly, programmed hours or a combination of programmed hours will be
selected.
To select the replay mode, press for a few seconds, time lights start to flash, replay mode is activated.
Programming time starts as soon as it is set. E.g.
If it was set at 8 a.m., the heater works as shown below.
Press  once to deactivate the replay mode.
to select the desired temperature. Depending on the temperature selected, light displayed is different; see
19 Grad
22 Grad
repeatedly until the light activates on the desired temperature (see figures 5.2).
The unit is programmed at 21ºC during 5 hours.
to select the temperature to reach.
The device is disconnected during 5 hours
The unit is set to connect and disconnect every 4 hours.
to turn on the radiator, ECO light turns on.
21 Grad
24 Grad
7