Tarm 2.5 Bedienungsanleitung Seite 15

Manual: tarm 2.5
(1) DJ Mode
To get laser output, DMX channel 1 needs to have a value greater than 0 (recommended
64 to 192)
Channel
1 Intensity
2 Pattern selection
3 Pattern speed
(Framerate)
4 Size
5 Automatic size
6 Rotate
7 Position X-axis coarse
8 Position X-axis fine
9 Position Y-axis coarse
10 Position Y-axis fine
11 Color effects
page 15 / 29
Mode Value
DJ 0
1 - 255
DJ 0
1 - 255
DJ 0 - 15
16 - 255
DJ 0 - 127
128 - 191
192 - 255
DJ 0 - 63
64 - 127
128 - 191
192 - 255
DJ 0 - 192
193 - 224
225 - 255
DJ 0 - 255
DJ 0 - 255
DJ 0 - 255
DJ 0 - 255
DJ 0 - 15
16 - 79
80 - 143
144 - 255
Function
Laser off
Increase intensity (full intensity = 255)
Blackout (000.ild must not exist)
Display patterns from SD card:
1 = 001.ild
2 = 002.ild
... and so on
If no pattern is assigned to a number = blackout
Standard speed: 50 fps
Increasing speed from 0 fps to 100 fps
Decreasing size X + Y-axis
Decreasing size X-axis
Decreasing size Y-axis
Full size
Changing size automatically X + Y-axis
(increasing speed)
Changing size automatically X-axis
(increasing speed)
Changing size automatically Y-axis
(increasing speed)
Manual rotation
Automatic rotation anti-clockwise
(increasing speed)
Automatic rotation clockwise
(increasing speed)
0 = center
0 = center
Show pattern in original colors
Show pattern in different colors (monochrome)
Re-color effects:
Original colors are replaced by new colors
Automatic change of re-color effects
(increasing speed)