Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Manual: tarm 2.5
e)
Master-Slave-Mode: Sound-to-Light
MASTER unit:
switch
1
On (1) / Off (0)
0
SLAVE units:
switch
1
On (1) / Off (0)
0
To have the same effects show on all connected units, it is required to have the same
pattern sets on all SD cards inside the units.
f)
Master-Slave-Mode: Demo Mode
MASTER Unit:
switch
1
On (1) / Off (0)
0
SLAVE units:
switch
1
On (1) / Off (0)
0
To have the same effects show on all connected units, it is required to have the same
pattern sets on all SD cards inside the units.
g)
ArtNet Operation
IMPORTANT: ArtNet operation requires the show laser system to be connected in a DHCP
environment (router with integrated switch is recommended). The address handling
must be managed through DHCP. For questions on DHCP, please refer to 4.1. DHCP Mode.
Only ShowNET interfaces and the ArtNet controller must be used in the same network.
Avoid using other network devices in the same network.
Use the dip switches to assign a certain address like in DMX mode:
switch
1
Binary DMX
1
channel offset
To activate ArtNet trigger, open the admin tool and navigate to the tab ‚Settings' . Then
change the ‚Data source for internal DMX effects' to ‚ArtNet input' as seen in the picture
below:
page 13 / 29
2
3
4
0
0
0
2
3
4
0
0
0
2
3
4
0
0
0
2
3
4
0
0
0
2
3
4
5
2
4
8
16
5
6
1
0
5
6
0
1
5
6
0
1
5
6
0
1
6
7
8
9
32
64
128
256
7
8
9
1
0
1
7
8
9
1
1
0
7
8
9
0
0
1
7
8
9
1
1
0
10
Switch 10 has to be ON (up)
for ArtNet operation
10
0
10
0
10
0
10
0
Werbung
Kapitel
Inhaltsverzeichnis
