JVC VU-V101 Bedienungsanleitung Seite 11

Replace the battery cover and rotate the battery
3
cover clockwise while pressing on the
indentations in the cover with your fingertips.
Rotate the cover until the markings on the battery cover are
aligned with the
NOTE • When replacing the batteries, always replace both cells.
• The effective life of the batteries varies significantly
depending on the battery manufacturer. When fitting or
replacing the button-cell batteries, use the batteries
supplied with the VU-V101 or CR2016 batteries
manufactured by Sanyo or Maxell.
Notes on Button-Type Lithium Batteries
• The performance of the batteries varies depending on operating
temperatures.
• To ensure that the contact surfaces of the battery are clean, wipe
the battery with a dry cloth before fitting it in the camera.
• Do not attempt to disassemble, heat above +100°C, recharge or
short-circuit the battery, or place the battery in a fire, as this could
cause the battery to split. When disposing of the battery, do so
responsibly and ensure that it is not burnt.
a
CAUTIONS
• Dispose of used battery promptly.
• Keep the lithium battery out of the reach of children. Should the battery be
swallowed, consult a doctor immediately.
• Wipe the battery with a dry cloth to assure good contact.
• Be sure to install the battery with the correct polarity.
• Do not hold the battery with metallic tweezers, as a short-circuit may occur.
j
WARNING
The battery may explode if mistreated. Do not recharge, disassemble or
dispose of in fire.
mark on the VU-V101.
Windows95
Battery cover markings
11