Lincoln PowerLuber Serie B Bedienungsanleitung Seite 11

SAFETY INSTRUCTIONS FOR CHARGER AND BATTERIES
This manual contains important safety and
operating instruction for Lincoln Model 1410
or 1410E Battery Charger.
Risk of Electric Shock 120 VAC or 240 VAC
present at charger terminals. Do not probe
with conductive objects. Do not charge
damaged battery. Replace immediately.
1. Before using a battery charger, read all
instructions and cautionary markings
on Battery Charger, Battery Pack, and
product using battery.
2. CAUTION: To reduce the risk of injury,
Lincoln Model 1410 or 1410E Chargers
should only be used to charge Lincoln
battery pack Model 1401. Other types of
batteries may burst causing personal in-
jury and damage. Do not charge Lincoln
Model 1401 Battery Packs with any other
charger.
3. Do not expose charger to rain, snow or
frost.
4. Do not abuse cord. Never carry charger
by cord or yank it to disconnect from
receptacle. Pull by plug rather than
cord when disconnecting charger. Have
damaged or worn power cord and strain
reliever replaced immediately. DO NOT
ATTEMPT TO REPAIR POWER CORD.
5. Make sure cord is located so that it will
not be stepped on, tripped over, or other-
wise subjected to damage or stress.
6. Do not use an extension cord unless
absolutely necessary. Use of improper
extension cord could result in a risk of fire
and electric shock. If an extension cord
must be used, make sure:
A That the extension cord is properly wired
and in good electrical condition.
B Wire Size of cord is at least as specified
in following chart:
LENGTH OF CORD IN FEET (M) 25 (7.5) 50 (15) 100 (30) 150 (45)
AWG SIZE OF CORD (mm²)
C If an extension cord is to be used out-
doors it must be marked with the suffix
W-A following the cord type designations.
For example -SJTW-A to indicate it is
acceptable for outdoor use.
7. Do not operate charger with damaged
cord or plug. Have them replaced im-
mediately, to avoid a hazard DO NOT
ATTEMPT TO REPAIR POWER CORD.
Form 402103
Model 1400, 1440, 1442, 1442E, 1444, 1444E
SAVE THESE INSTRUCTIONS
18 (1) 18 (1) 18 (1) 16 (1.5)
PowerLuber Grease Gun
8. Do not operate charger if it has received
a sharp blow, been dropped, or otherwise
damaged in any way, take it to a qualified
serviceman.
9. Do not disassemble charger or battery
pack. Take it to a qualified serviceman when
service or repair is required. Incorrect reas-
sembly may result in risk of electrical shock
or fire.
10. Unplug charger from outlet before attempt-
ing any maintenance or cleaning to reduce
risk of electric shock.
11. Charge the battery pack in a well venti-
lated place, do not cover the charger and
battery with a cloth, etc., while charging.
12. Do not store the charger or battery packs
in locations (such as a metal tool shed, or
a car in the summer) where the tempera-
ture may reach or exceed 122° F (50° C)
, which can lead to deterioration of the
storage battery.
13. Do not charge battery pack when the
temperature is BELOW 32° F (0° C) or
ABOVE 104° F (40° C). This is very impor-
tant for proper operation.
14. Do not incinerate battery pack It can
explode in a fire.
15. Do not charge battery in damp or wet loca-
tions.
16. Do not attempt to charge any other cord-
less tool or battery pack with the Lincoln
Model 1410 or 1410E charger.
17. Do not short across the terminals of the
battery pack. EXTREMELY HIGH TEM-
PERATURES COULD CAUSE PERSON-
AL INJURY OR FIRE.
18. Dispose of expended batteries properly.
The Lincoln Model 1401 Battery Pack con-
tains rechargeable, nickel-cadmium bat-
teries. These batteries must be recycled
or disposed of properly. Drop off expended
battery packs at your local replacement
battery retailer, or your recycling center.
Users in the United States NOTE:
Applicable fees for the collection and recy-
cling of these batteries have been paid to
the RBRCTM. For further information, call
1-800-8BATTERY.
Page Number - 11