Selecting The Temperature Unit - ADE WS 1700 series Bedienungsanleitung

2. Press the UP or DOWN button to set the upper
mould alert limit with a value of 60%, 65%,
70% or 75% (standard setting: 65%).
3. Press and hold the DOWN button again or
wait approx. 10 seconds until the display
returns to normal mode.
As soon as the humidity exceeds the set mould
alert value, there is a risk of mould formation.
In this case, the MOLD ALERT
symbols are shown on the display. In addition,
the red LED alarm signal blinks every 5 seconds.
− Press any button in order to stop the red LED
alarm signal.
The MOLD ALERT
displayed until the measured humidity once
again falls below the input mould limit value.

Selecting the temperature unit

− Briefly press the DOWN button once in order
to switch between the units of measurement
°C and °F.
Hygrometer WS 1700/1701
RISK OF MOLD symbols are
RISK OF MOLD
43