Inhaltsverzeichnis
Werbung
6
Cause of Faults, Remedial Action
► Outlet pressure rises above set value
Seal is dirty or cone seal leaking.
Remedial action:
Clean taper or replace if necessary.
► Outlet pressure falls below zero consumption
Seal untight, or spring hood insufficiently tightened.
Remedial action:
Replace seal, or retighten spring hood.
Declaration of conformity
according to Annex IV of the Directive 2014/68/EU
We, Goetze KG Armaturen, D-71636 Ludwigsburg
declare under sole responsibility that the delivered product:
Pressure-holding
equipment part
Pressure reducing valve
has been manufactured in compliance with the Directive 2014/68/EU and was
subjected to the following conformity assessment procedure:
Module A
The monitoring of the production quality assurance is performed by TÜV SÜD
Industrie Service GmbH (0036).
Ludwigsburg, 19.07.2016
(Place and date of issue)
D. Weimann
Management
Assembly and maintenance instructions - 683
Series
683
Nominal diameter
DN 10 – DN 32
www.goetze-armaturen.de
Werbung
Inhaltsverzeichnis
