Clearance Around The Tabletop; Screw Points On Tabletop - actiforce Solid 670 Betriebs- Und Montageanleitung

3.4.6 Clearance around the tabletop

25mm
Allow a minimum clearance of 25mm from the edge of a tabletop to a wall or moving
parts.
When changing the tabletop position (especially without using pinch protection), there
is a risk of pinching. You must therefore ensure that no people or objects are located in
the hazardous area or can reach into it.
To attach accessories under the tabletop, use only the green marked area. Don't screw
any screw on the top Surface of the tabletop.
Only use screws that are screwed into the material with a maximum length of 10 mm.

3.4.7 Screw points on tabletop

Cable position
Free mounting surface
EN
25mm
English - 15.