General Warnings; Intended Use - unGer STINGRAY Bedienungsanleitung

T
1. Safety Information
The user must comply with all applicable local and federal labor
laws and safety codes and standards. Prior to system installation
and start-up, it is essential that you observe the safety regulations
and instructions for installation and maintenance contained in this
manual.

1.1 General Warnings

To prevent damage to the surfaces, never clean LED, LCD, plasma or
similar monitors with this system.
Avoid spraying in the air. Place the cleaning pad on glass and spray in
short intervals.
Never use with more than one short and three long pole sections, for
a maximum pole length of 4,37m.
Follow all established safety procedures.
This product should be held and used based on the user's comfort
level.
Use all appropriate Personal Protective Equipment (PPE).

1.2 Intended Use

This cleaning tool is intended for indoor surface cleaning. This tool is
to be used by professionals only. Always take care that the device is
properly installed, regularly maintained and used only as intended.
The temperature in the working area should be between (5°C - 40°C /
40°F - 105°F).
8
Stingray® Cleaning System OS
Introduction & Warnings
www.ungerglobal.com