Assembly Of The Microfibre Pad; Assembly Of Adapter Plate & Quikpad; Extension Poles - unGer STINGRAY Bedienungsanleitung

Stingray® Cleaning System OS
Installation
5. Cap should have a tight seal prior to placing inside unit.
6. Do not use liquids other than conventional window and glass cleaners.
DO NOT USE with concentrates, creams, gels, abrasive formulas or chemicals
containing bleach.
7. Read label and safety data sheet (SDS) for each cleaning solution to ensure
proper use, including recommended surfaces.
8. Push the tank onto the connector at the top of the compartment with Unger logo
side facing up. (picture 3)
9. Push the tank forward and down so that it fits into the compartment.
10. Replace the lid and confirm that the green button is locked into place. (picture 4)
11. Test on small inconspicuous area before broad application.
3.2a Assembly of the Microfiber Pad
•
The system is equipped with a triangular shaped microfiber pad.
•
The pad provides maximum cleaning power in combination with the Stingray
Glass Cleaner.
•
Put the microfiber pad onto the padholder. Fix it in place with the elastic bands
in each corner.
•
When the pad is dirty, take it off and wash it. Please see care label on pad.
•
The area that can be cleaned with one pad will vary depending on the condition
of the surface being cleaned.
3.2b Assembly of the Adapter Plate & QuikPad
•
The system is compatible with the triangular shaped adapter plate and QuikPads.
1. Align the triangular adapter plate to the pad holder and press to lock into place.
2. Align the QuikPad with the corners of the adapter plate and press down to
secure.
•
When the pad is dirty, remove and dispose.
•
The area that can be cleaned with one QuikPad will vary depending on the
condition of the surface being cleaned.

3.3 Extension Poles

•
The handheld unit can be used as a hand tool for easy to reach surfaces (picture 5).
•
The handheld unit can be extended to reach higher or hard to reach surfaces using
the available short (0,63 m) or long (1,24 m) extension poles (see page 4).
•
The system is designed to use a maximum of three long and one short extension
poles. Never exceed maximum recommended length. UNGER is not liable for any
damages or injuries resulting from the failure to follow these instructions.
•
When adding extension poles, be sure locking pins are locked into corresponding
pin holes (picture 6).
•
To unlock, press the locking pin and separate the extension poles (picture 7).
www.ungerglobal.com
3
®
4
5
6
7
11