Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PLAYING BACK A RECORDED TAPE:
1. Press the [STOP/EJECT] button to open the cassette holder.
2. Insert the tape and close the holder. If playing a Cr02 tape, press the Cr02 button.
3. If connected to an amplifier system, make sure the amplifier is turned on and adjust its volume
to a suitable listening level.
4. Press the [PLAY] button to play the tape.
Please note:
If you are transferring tapes to your computer, it is possible to hear your tapes through your computer's
soundcard or built-in speakers while transferring.
FAST FORWARDING AND REWINDING:
1. While the deck is stopped, press the [FAST FORWARD] or [REWIND] button.
2. When the tape reaches the desired location, press [STOP/EJECT].
3. Press the [PLAY] button to play the tape from this location.
PAUSING:
1. Press the [PAUSE] button to pause the tape.
2. Press [PAUSE] again to release and resume playback.
STOPPING AND EJECTING:
1. Press the [STOP/EJECT] button while the tape is playing to stop playback.
1. 2. Press [STOP/EJECT] again to eject the tape.
Please use deck B for recording external sources or dubbing tapes.
RECORDING EXTERNAL SOURCE TO TAPE:
1. Press [STOP/EJECT] on deck B to open the cassette holder.
2. Insert a blank tape and close the cassette holder.
3. If recording to a Cr02 tape, press the [REC Cr02] button.
4. Press the [PAUSE] button and then press
5. Play your external source and check the levels on the display. Use the REC LEVEL knob to adjust
the level of the incoming audio signal.
6. Press the [PAUSE] button to begin recording when you are ready.
Tip:
The REC LEVEL knob can be used to make adjustments to the loudness of the incoming signal. If the
knob is in the center position, the incoming signal will be recorded at its original volume. Ideally, the
recording signal should come close but never hit red in the level indicator on the display. If the signal
is in the red, then turn down the REC LEVEL knob until it no longer reaches the red. If the signal is
too low and not close to the red, turn up the REC LEVEL knob.
DUBBING OPERATION:
1. Insert the tape for playback in deck A.
2. Insert the tape you wish to record to in deck B.
3. Press the [DUBBING] button. "Dubbing" will be illuminated on the display.
4. Select the dubbing speed with the [HI SP DUB] button. If the "HI SP DUB" indicator is
illuminated on the display, you will be dubbing in high-speed mode. If the indicator is not lit, then
you will be recording in normal-speed mode.
5. Press the [PAUSE] button on deck A, followed by the [PLAY] button to cue the tape.
PLAYBACK INSTRUCTIONS
RECORDING INSTRUCTIONS
[RECORD].
13
Werbung
Inhaltsverzeichnis
