auna multimedia 10010772 Bedienungsanleitung Seite 10

Do not wipe with thinners
 Wipe the panels and case from time to time with soft dry cloth. Using any kind of thinner, alcohol
or volatile liquid will mar the surface, cause blotching on the exterior and erase the markings and
should therefore be avoided. Do not use insecticide sprays in the vicinity.
Dripping warning
 The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids,
such as vases, shall be placed on the apparatus.
Positioning
 Use only the cart, stand, tripod, bracket or table specified by the manufacturer, or
sold with the apparatus. When a cart is used, use caution when the cart/apparatus
combination to avoid injury from tip-over.
Attachment/accessories
 Only use attachment/accessories specified by the manufacturer.
Power cord protection
 Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
Power Sources
 This product should be connected to a power supply only of the type described in these operating
instructions, or as marked on the unit.
Internal/External Voltage Selectors
 Internal or external voltage selector switches, if any, should only be reset and re-equipped with
a proper plug for alternative voltage by a qualified service technician. Do not attempt to alter this
yourself.
Servicing
 Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
SERVICE INSTRUCTIONS
 Disconnect power cord before servicing
 Replace critical components
 For AC line powered units - Before returning repaired unit to user, use an ohmmeter to measure
from both AC plug blades to all exposed metal parts. The resistance should be more than 100,000
ohms.
DANGER:INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR DEFEATED. AVOID
DIRECT EXPOSURE TO BEAM. USE OF CONTROLS OR ADJUSTMENTS OTHER THAN THOSE SPECIFIED
HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE
only with factory parts or recommended equivalents
10