Declaration Of Conformity - Simons Voss Technologies MOD.SOM8 Kurzanleitung

11. Declaration of conformity

11 Declaration of conformity
34 / 132
ATTENTION
Take voltage drop into account
The resistance in copper produces a voltage drop, the
size of which depends on the cable gauge, current flow
and cable length. The power supply lines must be ad-
equately dimensioned.
1. Ensure that the cable gauge in lines is adequate for
power supply. Use another suitable cable where
necessary.
2. If required, merge wire pairs to increase the cable
gauge.
3. Use a power source located closer to the Smart-
Output module if needed.
4. If possible, increase the supply voltage (observe
technical specifications).
The company SimonsVoss Technologies GmbH
hereby declares that article MOD.SOM8 complies with
the following guidelines:
2014/30/EU "EMC"

2011/65/EU "RoHS"

2012/19/EU "WEEE"

and regulation (EG) 1907/2006 "REACH"

The full text of the EU Declaration of conformity is
available at the following internet address:
www.simons-voss.com/en/certificates.html
MOD.SOM8
https://
.
EN