Santoemma FOAMTEC 70 Bedienungs- Und Wartungsanleitung Seite 15

Foamtec70 is made by the following parts:
• Machine body,
• foam/rinse pipe and vacuum tube,
• Foam/rinse accessory, to spray foam and rinse,
• pane wiper, floor wiper, accessories to vacuum hard floor,
• 2 tanks of special sanitizing chemical SANI-FOAM, 1 bottle of ANTI-FOAM.
• Optional accessories are also available, like the accessory with extension to spray
foam only.
The machine body contains all the necessary devices for spraying foam, rinsing and
vacuuming:
• The air compressor and the compressed air tank, both located in the lower part,
• The lower tank, containing the water used to create foam and rinse,
• The upper tank, used to recovery the dirt sucked with the vacuum motor,
• The solution pump and the vacuum motors, situated inside the lower tank,
• The control panel for the pump, the motors and the compressor,
• The regulation panel, to pass from foam to rinse mode and to adjust the type of foam.
Structure of the machine
15