Control Panel - Bahco BBCE612-2 Benutzeranleitung

8. AC POWER CORD CONNECTIONS
WARNING WARNING
DANGER
8.2
a proper outlet installed by a qualified electrician. An improper connection can result in a
risk of an electric shock or electrocution.
8.3 USING AN EXTENSION CORD
The use of an extension cord is not recommended. If you must use an extension cord,
follow these guidelines:
• Pins on plug of extension cord must be the same number, size, and shape as those of
plug on charger.
• Ensure that the extension cord is properly wired and in good electrical condition.
• Wire size must be large enough for the AC ampere rating of charger.
Recommended minimum AWG size for extension cord:
• 30.5 meters (100 feet) long or less – use an 1.31 mm
• Over 30.5 meters (100 feet) long – use a 2.08 mm
9. FEATURES
1
10. ASSEMBLY INSTRUCTIONS
10.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.

11. CONTROL PANEL

CLAMPS REVERSED (red) LED flashing: The connections are reversed.
CHARGING (yellow/orange) LED lit: The charger is charging the battery.
CHARGING (yellow/orange) LED flashing: The charger is in abort mode.
CHARGED (green) LED pulsing: The battery is fully charged and the charger
is in maintain mode.
NOTE: See Operating Instructions for a complete description of the charger modes.
RISK OF ELECTRIC SHOCK OR FIRE.
8.1 This battery charger is for use on a nominal 230V, 50/60Hz
circuit. The plug must be plugged into an outlet that is properly
installed and grounded in accordance with all local codes and
ordinances. The plug pins must fit the receptacle (outlet). Do not use
with an ungrounded system.
NEVER alter the AC cord or plug provided – if it does not fit the outlet, have
2
5
2
(14 gauge) extension cord.
2
3
1. AC Power cord
2. LED indicators
3. Hook attachment
4. Battery clamp quick-connect
5. Ring terminal quick-connect
4
• •
7
(16 gauge) extension cord.