2 Connecting The Microphone And; Attaching The Transmitter; 3 Switching The Transmitter On Or Off; Indications On The Display, Muting - JTS RU-G3TB/5 Bedienungsanleitung

•
If the unit is not in use for a longer period of
time, always remove the batteries as a pre-
caution to prevent damage due to battery
leakage
1) Push down the unlock button (6) to open the
battery compartment cover (7)
2) Insert the batteries with the positive and
negative poles as indicated in the battery
compartment
3) Close the battery compartment cover so that
it is locked
4) Instead of batteries, it is also possible to
insert two rechargeable NiMH (nickel-metal
hydrate) batteries of size AA To charge these
batteries, the charging station G3CH-2 is ide-
ally suited: Leave the batteries in the pocket
transmitter and insert the transmitter into a
charging slot Power is supplied via the lateral
contacts (4)
Used batteries and defective recharge-
able batteries must not be placed in
the household waste To protect the
environment, always take them to a
special waste disposal, e g collection
container at your retailer

3.2 Connecting the microphone and

attaching the transmitter

1) Connect the microphone provided to the mini
XLR jack (9) and use the clip to attach the
microphone to your clothes (e g tie or lapel)
It is also possible to use a different JTS micro-
phone with a 4-pole mini XLR plug
2) When all settings have been made on the
transmitter, use the clip on the rear of the
transmitter to attach it to your clothes (e g
belt or waistband)

3.3 Switching the transmitter on or off,

indications on the display, muting

the microphone

1) Briefly press the button
the transmitter The switch MUTE (8) lights
up in green; the backlight of the display (12)
lights up, but will go dark after a few seconds
When you press a button, the backlight will
immediately be switched on again
12
2) The display can show the following informa-
3) To briefly mute the microphone connected
4) To switch off the transmitter, keep the button

3.4 Settings

The pocket transmitter RU-G3TB / 5 can be set via
(5) to switch on
a menu (fig 1) or most conveniently from the
receiver RU-901G3 / 5 by means of the REMOSET
function (chapter 3 4 2): When the settings for
RU-G3TB / 5 have been made on the receiver,
they can be transferred to the pocket transmitter
by the press of a button
When the symbol
flashes and the switch MUTE (8) lights up
in red, the batteries are discharged As an
additional indication, the display backlight of
the receiver RU-901G3 / 5 will change to red
tion:
Indication Meaning
Transmission power: high (50 mW)
When the microphone is muted,
the transmitter will automatically be
switched off after an adjustable time
(preset time: 10 minutes)
Microphone muted by means of the
MUTE switch (8)
Battery status
–
full
Key lock activated
Group number (1 ... 6)
and channel number (1 ... 22)
as an alternative
transmission frequency
(506.000 ... 542.000 MHz)
Fig. 3 Information on the display
(e g in speech or music pauses), slide the
MUTE switch to the position MUTE: The
switch will start flashing and the symbol
will be shown on the display
When the symbol
display, the transmitter will automatically
switch off after an adjustable time to save
the batteries To change the time or to deac-
tivate the automatic switch-off function, see
chapter 3 4 1
pressed for 2 seconds until OFF is shown
on the display
on the display
low (10 mW)
– –
discharged
is shown on the