Herunterladen Inhalt Inhalt Diese Seite drucken

Operating Elements And Connections; Important Notes; Power Supply - JTS PT-920BG Bedienungsanleitung

Uhf-taschensender
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Please unfold page 3. Then you can always see the
operating elements and connections described.

1 Operating Elements and Connections

1 Transmitting antenna
2 Power switch
3 Indication of the transmission group and the trans-
mission channel (also see table fig. 3 on page 8)
4 Microphone connection (4-pole mini XLR jack)
5 Key
for scanning the transmission group/chan-
nel in ascending order (in the group adjusting
mode/channel adjusting mode) and for activating
the locking function (in the lock adjusting mode)
6 Key
for scanning the transmission group/chan-
nel in descending order (in the group adjusting
mode/channel adjusting mode) and for deacti-
vating the locking function (in the lock adjusting
mode)
7 Indication of the battery status
8 Key SET
with the unit not locked:
to recall and to exit the adjusting modes for the
transmission group/channel, locking function
→ chapters 5.1 and 5.2.1
with the unit locked:
to recall and to exit the adjusting mode for the
locking function → chapter 5.2.2
9 Gain control; for matching the input sensitivity turn
the control with the adjusting key supplied
10 Battery compartment for two 1.5 V batteries of size
AA (R6)
11 Cover of the battery compartment

2 Important Notes

The unit corresponds to all required directives of the
EU and is therefore marked with
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 0 – 40 °C).
For cleaning only use a dry, soft cloth; never use
chemicals or water.
No guarantee claims for the unit and no liability for
any resulting personal damage or material damage
will be accepted if the unit is used for other purposes
than originally intended, if it is not correctly operated
or not repaired in an expert way.
Downloaded from
www.Manualslib.com
.
manuals search engine
If the unit is to be put out of operation defini-
tively, take it to a local recycling plant for a
disposal which is not harmful to the environ-
ment.
Dead batteries or defective rechargeable batteries
do not belong in the household rubbish; always take
them to a special waste disposal (e. g. collecting con-
tainer at your retailer).
3 Applications
Together with the multifrequency receiver US-903DC-
PRO from JTS this multifrequency pocket transmitter
makes up a wireless audio transmission system. The
transmitter operates with four transmission groups
(A – D) to which 16 transmission channels are assigned
respectively, i. e. altogether 64 factory-set transmission
channels are available. These channels in the UHF
range of 790 – 814 MHz can be selected as desired.
The pocket transmitter is supplied with the Lavalier
microphone CM-501. Instead of the CM-501 it is also
possible to use e. g. the headband microphones
CM-204... and CX-504 or the instrument microphones
CX-508W and CX-516W from the JTS product range.
3.1 Conformity and approval of the transmitter
The pocket transmitter has been tested according to
the relevant standards of the R + TTE directive. The
declaration of conformity can be found in the Internet
on the JTS home page (www.jts-germany.de).
In the Federal Republic of Germany, the frequency
range of 790 – 814 MHz is generally assigned, how-
ever, the general assignment of individual frequencies
of the range is subject to the type of use [see the direc-
tive 91/2005 on the home page of the Bundesnetz-
agentur (Federal Network Agency):
www.bundesnetzagentur.de].
In other countries, different legal regulations may
apply for wireless systems operating in this frequency
range. Therefore, please contact the MONACOR sub-
sidiary or the corresponding authorities of the country
prior to setting the system into operation outside
Germany.

4 Power Supply

Only insert batteries of the same type and always
replace all batteries.
If the unit is not used for a longer period (e. g. more
than a week), remove the batteries. Thus, the unit
will not be damaged in case of battery leakage.
1) Open the Velcro fastener and take the transmitter
out of the belt bag.
®
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis