4 2 Remoset Function; Specifications; Power Supply - JTS RU-G3TB/5 Bedienungsanleitung

3.4.2 REMOSET function
For the REMOSET function, make sure that
1 the pocket transmitter is switched on; the
distance between pocket transmitter and
receiver is 10 – 50 cm The vertical angular
deviation with respect to the ultrasonic trans-
mitter (symbol
exceed ±30°
−30° +30°
Fig. 5 Distance during REMOSET transmission
2 no menu is called up on the transmitter; the
receiver is not in the setting mode
3 the symbol
the display does not flash
4 If you do not only want to set the pocket
transmitter to the group and the channel
or transmission frequency but also want to
change the microphone sensitivity or the
transmission power, for example, change the
Remoset Configuration on the receiver from
RC FRE to RC ALL (see instruction manual of
the receiver RU-901G3 / 5)
14
) of the receiver must not
RU-901G3/5
(= batteries discharged) on
To transfer settings from the receiver to the
pocket transmitter: Press the button REMOSET
on the receiver As soon as the settings on the
transmitter have been made, the LED REMOSET
(3) will light up in blue for approx 5 seconds
If the LED only flashes a few times, auto-
matic synchronization of the transmitter has
failed For troubleshooting, see items 1 – 3 at
the beginning of this chapter Then press the
button REMOSET on the receiver again

4 Specifications

Carrier frequency range: 506 – 542 MHz
Transmission power (EIRP)
Low:
High:
REMOSET transmission: ultrasonic
Audio frequency range: 50 – 18 000 Hz
Ambient temperature:

Power supply:

Operating time:
Dimensions
(W × H × D):
Weight:
Microphone connection: 4-pole mini XLR jack
1
4
2
3
Fig. 6 Microphone jack
1 = ground
2 = 5 V operating voltage for the microphone
3 = signal input
4 = impedance correction
Subject to technical modification
10 mW
50 mW
0 – 40 °C
2 (rech ) batteries of
size AA
> 12 h with
3400 mAh rech
batteries
62 × 80 × 23 mm
300 g