Inhaltsverzeichnis
Werbung
EN
About This Guide
The Wash FX2 Quick Reference Guide (QRG) has basic product information such as mounting, menu options, and DMX
values. Download the User Manual from
Disclaimer
The information and specifications contained in this QRG are subject to change without notice.
Safety Notes
These Safety Notes include important information about installation, use, and maintenance.
·
Always connect the product to a grounded circuit.
·
Make sure the power cord is not crimped or damaged.
·
Always disconnect the product from the power source before cleaning it or replacing the fuse.
·
Never disconnect the product from the power source by pulling or tugging on the cord.
·
If mounting the product overhead, make sure there is adequate support for the product's weight
and always secure the product using a safety cable.
·
Make sure there are no flammable materials close to the product when it is operating.
·
Avoid direct eye exposure to the light source while the product is on.
·
Do not touch the product's housing when the product is operating because the housing can be
very hot.
·
The product is not intended for permanent installation.
·
The product is for indoor use only. It is rated at IP20.
·
Do not expose the product to rain or moisture.
·
Always connect the product to a power source that is within the voltage range stated on the label
or rear panel of the product.
·
Never connect the product to a dimmer or rheostat.
·
Make sure to replace the fuse with another of the same type and rating.
·
Always install the product in a location with adequate ventilation.
·
Always leave at least 20 in (50 cm) between the product and adjacent surfaces.
·
Be sure that no ventilation slots on the product's housing are blocked.
·
Do not operate the product at an ambient temperature higher than
104 °F (40 °C).
·
Never carry the product by the power cord or any moving part.
·
Always use the mounting/hanging bracket to lift the product.
·
If there is a serious operating problem, stop using the product immediately.
·
Never try to repair the product. Repairs carried out by untrained people can lead to damage or
malfunction.
·
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect from
power via breaker or by unplugging it.
Contact
Outside the U.S., United Kingdom, Benelux, France, Germany, Ireland, Mexico, or Benelux, contact your distributor to
request support or return a product. Visit
What is Included
•
Wash FX2
•
Power Cord
•
Warranty Card
•
Quick Reference Guide
To Begin
Unpack your Wash FX2 and make sure you have received all parts in good condition. If the box or contents appear
damaged, notify the carrier immediately, not Chauvet.
1
QUICK REFERENCE GUIDE
www.chauvetdj.com
for more details.
www.chauvetdj.com
for contact information.
Wash FX2 QRG Rev. 2
Werbung
Inhaltsverzeichnis
