Cylinder Strap Set Up And Attachment (Single Cylinder) Super Cinch Q.a. (Quick Adjust.) (Some Models) - Scubapro X-Black Bedienungshandbuch

! WARnInG
Do not attach a L.P. hose to a SCUBA regulator high pressure (HP) port or to an air
supply with pressure in excess of 200 psi (13.8 bar). This may result in damage or
explosive failure of the Inflation Valve or Low pressure Hose, which could result in
injury or death.
5.1 Cylinder strap set up and attachment (single cylinder)
super cinch q.a. (quick adjust.) (some models)
The SCUBAPRO Super Cinch Q.A. cylinder strap allows you to easily fasten your BC to any
single SCUBA cylinder.
Set up for a single SCUBA cylinder must be accomplished following these steps:
1. Wet the webbing of the Super Cinch Q.A. cylinder strap prior to tightening. Wrap the
Super Cinch Q.A. (W1) strap (fig. 2 – 1) around the SCUBA cylinder and insert the
end of the stainless steel buckle (B) into the trapezoidal "D" ring (DR1) (fig. 2 – 1).
Position the SCUBA cylinder so that the cavity (S) of the back plate corresponds to the
cylinder shoulder (fig. 2 – 2) with the lever (B) close to the back pack (BP) (fig. 2 – 3).
The cylinder locator strap (L ) (fig. 2 – 2), on the top of the back plate, encircling the valve
neck of the cylinder, prevents the back pack strap assembly from sliding down, while
connecting and tightening the Super Cinch Q.A. Once correctly adjusted, it helps to easily
and consistently find the correct position.
2. Close the buckle (C) (fig. 2 – 3). If the
webbing strap is too tight to close or too
loose to grab the SCUBA cylinder, open the
velcro fastener on the webbing and readjust
the length of the Super Cinch Q.A. (W1)
webbing (fig. 2 – 1). For extra safety, slide
the loop (SL) (fig. 2 – 1) around the webbing
end (T). With SCUBA cylinder in place, lift
the assembly by the back pack handle and
shake firmly to check for secure fastening.
Try to move the backpack up and down on
the SCUBA cylinder. If there is movement,
the band is not tight enough.
! WARnInG
To prevent accidental loss of the cylinder, ensure the strap is done up tightly enough
so that the cylinder cannot move or slide on the BC. Failure to do so could result in
injury or death.
fig. 2-1
DR
1
SL T W B
1
SL T
W
1
B
C
fig. 2-3
BP
fig. 2-2
L
S
W
1
SL T
5