Instructions For Sending For Repair Or; Diagnostic Purposes; Maintenance; Blade Maintenance - IKRA Mogatec ARM 4037 Gebrauchsanweisung

Instructions for sending for repair or

diagnostic purposes:

• Only send batteries if the housing is not damaged.
Risk of short circuit!
The battery must be packed (plastic bag, case)
when disposing, transporting or storing, or the
contacts must be covered.

Maintenance

Rotating blade
Work/adjustments on the device may only
be carried out when the motor is switched off, the
ignition key is removed and the cutting blade is
at a standstill.
Switch the device off and remove the igni-
tion key before carrying out any adjust-
ment or maintenance work. Wait until all
rotating parts have come to a standstill and the
device has cooled.
Always keep the device clean. Clean the grass
discharge and the housing on a regular basis.
Treat all moving parts with environmentally friend-
ly oil.
Check the catcher bag for wear and ageing.
Only have repairs carried out by qualified specia-
lists.
Only use original accessories and original spa-
re parts. A device can only be a satisfactory aid
when it is regularly maintained and well cared for.
A lack of maintenance and care can cause unfo-
reseeable accidents and injuries.
GB | Operating Instructions

Blade maintenance

off, remove the ignition key, the battery and the
grass catcher box.
• Place the machine on its side to inspect the
• To replace the blade, proceed as follows:
• Ensure that the blade is secured properly be-

Transport

• When transporting the machine by car, it must
18
Attention! Before carrying our mainte-
nance or cleaning work, switch the device
Always wear work gloves when you
are handling or working in the sharp
blade area.
blade (A). Replace a blunt or damaged blade.
- Hold the blade (A) with work gloves (not sup-
plied) and use a screwdriver (not supplied) to
remove the blade's screw (B). You can then
remove the blade.
- Install it by following the procedure in reverse
order. Place a new blade (A) on the drive pla-
te (D). Screw the screw (B) with the washer
(C) in and use a spanner to tighten it.
fore starting up.
be positioned so that it poses no danger, and
secured.
(see figure 4/page 11)