Important: Safety Guidelines; Installation; Electrical Connection - Ventur COR-F Gebrauchs- Und Montageanweisung

ENGLISH
Except for the COR-F / COR-2F, which can only be used as an Air Curtain using fresh air, the rest of
the models in this range have the possibility of working either with fresh or warm air.
We ask you to check that the unit is in perfect condition when unpacking it, as any manufacturing or
quality defect is covered by the S&P guarantee.

IMPORTANT: SAFETY GUIDELINES

– The appliance must not be right above or below a socket.
– While in operation, the connection cable must not be in front of the air outlet.
– Keep the inlet and outlet grilles clean. When cleaning them, disconnect the unit from the mains
supply.
– Do not manipulate the unit with wet hands.
– The installation must be carried out by an electrician.
IMPORTANT: THIS APPLIANCE MUST BE EARTHED.
– The electrical isolating switch must have a gap of at least 3 mm on all poles.

INSTALLATION

kept.
4- Remove the front cover.
5- Hang the Air Curtain using the screws already on the wall.
6- Adjust the level in both horizontal and vertical directions. In case that the mounting surface is not

ELECTRICAL CONNECTION

each installation.
Connect the unit to the mains supply, checking that the voltage and frequency are the same as those
indicated on the rating plate. Use the cables with the number of wires and cross section as indicated
on the wiring diagram for every model.
8